Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
tinyidiot [2018/12/20 21:44] – [code] yair | tinyidiot [2018/12/26 14:55] – yair | ||
---|---|---|---|
Line 7: | Line 7: | ||
tinytony for esp8266 | tinytony for esp8266 | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== drv8833 === | ||
+ | https:// | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== drv8830==== | ||
drv8830 [[http:// | drv8830 [[http:// | ||
built of work by sparkfun [[https:// | built of work by sparkfun [[https:// | ||
Line 13: | Line 22: | ||
{{: | {{: | ||
- | {{: | ||
##wiring | ##wiring | ||
Line 32: | Line 40: | ||
* GND of USB serial etc. and GND of ESP - WROOM - 02 board | * GND of USB serial etc. and GND of ESP - WROOM - 02 board | ||
+ | |||
+ | {{: | ||
+ | "From this table, the write address is 0xC0 and the read address is 0xC1. The device address specified from Arduino will be " | ||
==== code ==== | ==== code ==== | ||
https:// | https:// | ||
+ | ===i2c issues== | ||
+ | |||
+ | cant get any other address to motors but 0x64 | ||
+ | #define PIN_WIRE_SDA (4) | ||
+ | #define PIN_WIRE_SCL (5) | ||