Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
molds [2018/12/27 13:38] – yair | molds [2018/12/27 20:37] – [Intro] yair | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | molds for sugar need to be safe for consumption (even if not directly wallowed) and at temperature of 160c (sugar base goes up to 146C but better safe) | ||
- | {{ : | ||
- | {{ :pasted: | + | ====Intro==== |
+ | molds for sugar need to be | ||
+ | *safe for consumption (even if not directly wallowed) | ||
+ | *hold at temperature of +160c | ||
+ | *sugar base goes up to [[https:// | ||
- | {{ :mold2.jpg?500 }} | + | when making multiple impressions in a single mold, [[https:// |
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | see more at http:// | ||
+ | |||
+ | ====Results==== | ||
+ | {{: | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ :mold2.jpg?400 }} | ||
====make mold==== | ====make mold==== | ||
Line 24: | Line 38: | ||
==== RTVs==== | ==== RTVs==== | ||
{{: | {{: | ||
+ | |||
+ | watchout for | ||
+ | * [[https:// | ||
+ | *[[https:// | ||
+ | * shelf life - always look at datasheet | ||
+ | * 20 month sometimes less. the smoothOn was opened and was all stiff | ||
+ | * the platinum base was much more viscous a day after opening. not a good sign. | ||
+ | * {{: | ||
+ | * | ||
+ | |||
+ | ==== volume ==== | ||
+ | we tried water, kuskus and ploymorph pallets.\\ | ||
+ | |||
+ | but best is to [[https:// | ||
+ | |||
+ | {{: | ||
+ | |||
+ | calculate 3d volume from simplify3D = 22.5 per bit | ||
+ | |||
+ | (22.5*4)/ | ||
+ | |||
+ |