Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
mini_flow [2018/12/27 22:42] – yairmini_flow [2018/12/28 15:55] – [test setup] yair
Line 19: Line 19:
  
 placed the ceramic heater on top of a huge copper heatsink (idiot) placed the ceramic heater on top of a huge copper heatsink (idiot)
 +
 +
  
 {{:pasted:20181227-201019.png?400&direct}} {{:pasted:20181227-200604.png?400&direct}} {{:pasted:20181227-201019.png?400&direct}} {{:pasted:20181227-200604.png?400&direct}}
Line 28: Line 30:
 a quickiFX(?) low temp solder zipped into place\\ a quickiFX(?) low temp solder zipped into place\\
 i was shocked by the low temp i couldn't believe my eyes and kept ramping the current to yjr expected 220 :) i was shocked by the low temp i couldn't believe my eyes and kept ramping the current to yjr expected 220 :)
 +
 +{{::bake-720p.mp4?700x500|}}
  
 {{:rec013_shrt.mp4?700x500|}} {{:rec013_shrt.mp4?700x500|}}
Line 46: Line 50:
 {{:pasted:20181227-104729.png?400}} {{:pasted:20181227-104729.png?400}}
  
 +==== PID ====
  
 +https://electronics.stackexchange.com/questions/215418/smartest-way-to-use-current-limit-using-lm317
 +and polyfuse?