Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
mini_flow [2018/12/27 22:38] – [to test] yair | mini_flow [2018/12/28 15:55] – [test setup] yair | ||
---|---|---|---|
Line 6: | Line 6: | ||
mybe call it uBake ? | mybe call it uBake ? | ||
- | ==== setup ==== | + | ==== test setup ==== |
+ | |||
+ | {{: | ||
first tested on bench with no heat load.\\ | first tested on bench with no heat load.\\ | ||
Line 14: | Line 16: | ||
using a benchtop psu or lm317(?) you can make a very simple reflow profile.\\ | using a benchtop psu or lm317(?) you can make a very simple reflow profile.\\ | ||
- | {{ :: | + | {{:: |
placed the ceramic heater on top of a huge copper heatsink (idiot) | placed the ceramic heater on top of a huge copper heatsink (idiot) | ||
+ | |||
+ | |||
{{: | {{: | ||
- | then moved to a more suitable setup and it was a breeze | + | then moved to a more suitable setup |
- | {{: | + | {{: |
- | {{: | + | a quickiFX(?) low temp solder zipped into place\\ |
+ | i was shocked by the low temp i couldn' | ||
- | a quickiFX(?) low temp solder didn't zip into place\\ | + | {{:: |
- | i was shocked by the low temp i couldn' | + | |
{{: | {{: | ||
Line 46: | Line 50: | ||
{{: | {{: | ||
+ | ==== PID ==== | ||
+ | https:// | ||
+ | and polyfuse? |