Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
box [2020/06/14 10:19] – [multi unit] yair | box [2020/06/17 18:59] – yair | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====T12 Kit ==== | + | ====multi soldering station |
- | ====multi unit==== | + | laser cut box generated using benjolin case [[https://www.openscad.org/|openscad]] script by [[office@stahlnow.com|stahl]] |
- | [[https://github.com/idiot-io/ | + | |
- | {{: | ||
- | | ||
- | ===power supply=== | + | **take note**\\ |
+ | *in the laser folder at git you have a '' | ||
+ | *we use the front.dxf for both front and back, and they represent the position of the controls | ||
+ | {{: | ||
+ | \\ | ||
+ | *when exporting the panel from inkscape | ||
+ | * make sure to save as DXF | ||
+ | * set the '' | ||
+ | {{: | ||
+ | \\ | ||
+ | *no splines or curves, make sure to break them before exporting | ||
+ | {{: | ||
+ | \\ | ||
+ | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | === media=== | ||
+ | |||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | ====power supply==== | ||
we currntly use a 120W laptop power supply as it is slim and capable. | we currntly use a 120W laptop power supply as it is slim and capable. | ||
**power chart for hakko T12**\\ | **power chart for hakko T12**\\ | ||
{{: | {{: | ||
- | ====single unit==== | ||
- | [[https://github.com/ | + | ====single unit==== |
+ | {{:chrome_ngl7ixn548.png}} | ||
{{: | {{: |